Delta Virtual Airlines Water Cooler - Uncommanded Rudder Actions

Delta Virtual Airlines Water Cooler | PC Support | Uncommanded Rudder Actions

DVA5001
Senior Captain, MD-88
OLP, 737-ATP

Joined on September 16 2007
B757 100 Club
50 State Club
Everett 500 Club
Million Mile Club
Globetrotter
Online Century Club
Quad-Jet Quartermaster
White Knuckles Club
US Capital Club
Flying Colonel
DVA Fifteen-Year Anniversary

Lake Dallas, TX USA

1,791 legs, 4,744.0 hours
131 legs, 236.5 hours online
1,728 legs, 4,603.4 hours ACARS
19 legs, 36.8 hours event

Posted onPost created on August 13 2019 20:50 ET by Art Forsha

Hello fellow simmers. I was just wondering what other ideas may abound. I have suddenly been plagued with a full rudder deflection every maybe 10 seconds or so and always with the left rudder. It doesn't happen with my other flight sim (DCS). It happens with every aircraft in P3Dv4. I've re calibrated my controls both in the sim and out and it still seems to happen. I can't figure out why P3D is affected but not DCS. One would think if it really were a hardware issue then both platforms would see the same issue.

Any ideas?

Thanks.

Art Forsha

Senior Captain, MD-88

DVA9545
Senior Captain, B777-200
OLP, 737-ATP

Joined on March 03 2011
50 State Club
Globetrotter
Quad-Jet Quartermaster
US Coastal Club
US Mountaineer Club
Million Mile Club
Events Double Century Club
DVA Ten-Year Anniversary
Toulouse 500 Club
Bi-Millennium Club
Online Twenty Century

"YUPIIIII"
Goiás Brazil

2,492 legs, 5,039.3 hours
2,321 legs, 4,760.9 hours online
2,484 legs, 5,009.7 hours ACARS
271 legs, 683.8 hours event

Posted onPost created on August 13 2019 21:54 ET by Thiago Braga

I use the Seitek Rudders.

Thiago Braga (DVA9545)

DVA388
Senior Captain, B747-400
OLP

Joined on December 14 2001
50 State Club
B757 100 Club
US Coastal Club
US Mountaineer Club
Online Century Club
Stage 1 Jet Triple Century Club
Globetrotter
DVA Twenty-Year Anniversary
Millennium Club
Million Mile Club

Midwestern United States

1,252 legs, 2,773.2 hours
153 legs, 178.1 hours online
1,172 legs, 2,643.0 hours ACARS
10 legs, 22.0 hours event
39 legs dispatched, 67.6 hours

Posted onPost created on August 13 2019 23:01 ET by David Vega

Does it happen if you completely disconnect the controller?

DVA3672
Senior Captain, A320
OLP
E-MAIL

Joined on October 29 2006
B757 100 Club
50 State Club
Two Million Mile Club
Bi-Millennium Club
DVA Fifteen-Year Anniversary
US Capital Club
Toulouse Millennium Club
Online Fifteen Century

"Chris, NOT in Seattle"
Northeastern United States

2,534 legs, 6,223.1 hours
1,537 legs, 3,252.2 hours online
2,243 legs, 5,407.0 hours ACARS
4 legs, 6.0 hours event
2 legs dispatched, 19.5 hours

Posted onPost created on August 14 2019 09:43 ET by Chris Frasure

Art, make sure you don't have any spikes occurring in the equipment. It sounds like a rudder hardware issue. Go into FSUIPC and check the box that prevents spikes. That helped me.

DVA13608
Captain, A320

Joined on January 26 2019
Moose Club
Century Club
Eurocap Club
Toulouse Century Club
Online Century Club

Edmonton, AB Canada

143 legs, 242.3 hours
140 legs, 235.1 hours online
140 legs, 238.3 hours ACARS

Posted onPost created on August 14 2019 18:45 ET by Gerard Beekmans

Spikes aside, I also once had a "simple" misconfiguration where I had two axis in P3D set to rudder. One was the actual rudder and the other was some joystick axis. Either way, I would do something and had unanticipated rudder action, too. At one point in my life I had managed to link mouse movement to an axis so every time I touched the mouse, to click a button or switch in the plane, it caused erratic behaviour.

You'd have to go through your P3D setup carefully to see what all is configured for rudder. Check box axis and buttons as perhaps it's caused by keyboard, mouse or joystick button presses too.

Gerard Beekmans

Captain, A320

Posted onPost created on August 16 2019 16:29 ET by Art Forsha

David, I will check. I'm doubtful it's a configuration issue. I haven't touched anything in the configuration settings and all of a sudden it started. I'm leaning toward a problem with the controller, I'm just trying to make sense why it's not happening in other platforms

Art Forsha

Senior Captain, MD-88

DVA2134
Captain, CRJ-200

Joined on February 12 2005
Stage 1 Turboprop Century Club
Triple Century Club
DVA Twenty-Year Anniversary

Louisville, KY USA

321 legs, 503.1 hours
1 legs, 2.3 hours online
97 legs, 132.4 hours ACARS

Posted onPost created on August 29 2019 17:34 ET by Vince Benningfield

I made my own rudder pedals and joined them with my joy stick and have never had any problems, if you would like to know how i did it let me know and i can help you.

Vince Benningfield

Captain, CRJ-200

Posted onPost created on October 18 2019 08:16 ET by Chris Frasure

My suggestion would be to check all your control axis in P3D and be certain that P3D did not assign that axis to a second control. This happened to me. Then I would go into FSUIPC and turn off control spikes.

Posted onPost created on October 18 2019 08:16 ET by Chris Frasure

Sorry and I didn't see GB's response. I agree with him

For flight simulation purposes only. Not a commercial website. In no way are we affiliated with Delta Air Lines, its affiliates, or any other airline. All logos, images, and trademarks remain the property of their respective owners. Delta Virtual Airlines is a non-profit entity engaged in providing an avenue for flight simulation enthusiasts.